Announcement Triggering
  • 13 Jun 2024
  • 1 Minute to read
  • PDF

Announcement Triggering

  • PDF

Article summary


Description
Once the network settings and configuration including zones are set in Q-SYS designer, Live paging can be triggered with the PTT button.
Important
Which mode is used depends on Paging configuration of your micnode mini device in Q-SYS designer.




  1. Select on your micnode mini device the zone/s to which your announcement is to be paged by clicking on the zone selection button/s. The selected button/s will light up.
  2. Start your announcement by pressing the Talk/Start button on the microphone side.

 

Control LED Paging Status

Ready to page

Yellow LED

At least one zone button selected and zones are available

Busy

Red LED

At least one zone button selected and one zone at least is selected

No Zone selected

LED off

No zone button is selected

Starting PTT button – Waiting in Queue

 

Yellow LED, fast blinking

At least one zone button is selected, PTT button is pressed but at least one zone is occupied by same or higher priority

Talk - Ready

Green LED, slow blinking

PTT button pressed and live call is in progress.

Stop call

Green LED, no blinking

Let go the PTT button, the call is done.

Stopped by higher priority

Red LED, first 4times blinking and the busy zone

Your call was interrupted by an other announcement with higher priority paged in the same zone.


Was this article helpful?