Microphone Replacement
  • 25 Oct 2023
  • 1 Minute to read
  • Dark
  • PDF

Microphone Replacement

  • Dark
  • PDF

Article Summary

Replace the microphone on your micnode2 paging station.

A. Remove the 4 screws from the magnetic docking plate from the device.
B. Open the chassis by moving the microphone cable with light side-to-side movements and remove the docking plate.

C. Unplug the connected microphone by pressing the beak on the top of the connector and pulling it out of the socket.
D. Remove the cable from the docking plate by pulling the cable out with light force.
E. Connect the NEW microphone by plugging the microphone connector into the Ethernet port. 

F. Remove the cable strain relief  from the old microphone cable and place it on the cable of the new microphone.
  • Secure the cable strain relief around the cable.
  • Gently bend the cable so that it is not kinked and pull it through the hole at the bottom and out of the device.
G. Put the docking plate back in place.

  • Push the cable strain relief  into the hole with the cable pointing downwards and secure it by pushing the palm of your hand from the top towards the device until the cable strain relief clicks into place.
  • Reattach the 4 screws on the device. 

The micnode2 device is ready to use with the new microphone. 

Was this article helpful?

What's Next